Presses for Special Applications
ASTM Molding Presses for Test Specimens of Plastics, Elastomers and Other Materials
Carver has developed the hydraulic bench top press which is specially configured to perform the ASTM compression molding of test plaque or bar specimens of Type I, II, III or IV polyethylene and other thermoplastic resins. The procedure is in conformance with ASTM Method D 4703, Procedure C. The compression molding presses are equipped with heating/cooling platens and a programmable digital controller which has a heating/cooling loop for each platen and built-in program for the required 15°/minute ±2°C cooling rate.
No. 4391-ASTM Model 12-12H-ASTM, 12 tons
Bench top, four-column manual press with heating/cooling platens and programmable controller
|
 |
 |
Carver reserves the right to change specifications without notice. Presses and accessories may differ from photos shown.
Carver strongly recommends the use of a safety shield and personal protection equipment when operating Carver equipment.
|
|
