Hydraulic Lab Presses for ASTM Molding Test Specimens, in Plastic, Elastomers and Other Materials
Carver has developed the ASTM Molding Presses which are specially configured to perform the compression molding of test plaque or bar specimens of Type I, II, III or IV polyethylene and other thermoplastic resins. The procedure is in conformance with ASTM Method D 4703, Procedure C. The press is equipped with heating/cooling platens and a programmable digital controller which has a heating/cooling loop for each platen and built-in program for the required 15°/minute ±2°C cooling rate.
No. 3710-ASTM
Model B, 30 Tons
CMG30H-12-ASTM Molding Press
Floor standing, four column, automatic press with heating/cooling platens and programmable controller.
|
|
|
 |
Carver reserves the right to change specifications without notice. Presses and accessories may differ from photos shown.
Carver strongly recommends the use of a safety shield and personal protection equipment when operating Carver equipment.
|
|
